Avrdude%3a Stk500_recv()%3a Programmer Is Not Responding

 admin

Hi. I've recently bought a uno board starter kit from sparkfun, which i am running on a g4 powerbook with os x 10.5. but am having problems uploading the blink example.

I recently bought an Arduino Pro Mini(3.3V 328p, 8MHz) along with a CP2102 USB to TTL UART convertor. When I try to upload a sketch to the Pro Mini using it, I get a avrdude:stk500recv: programm.

I am able to upload the program once and the sequence runs fine, but if i try to upload again (if i alter the code for example) i get the message:

avrdude: stk500_recv(): programmer is not responding.

  1. Buy access to all our courses now - For a limited time just 19USD per month with a 30 day satisfaction or your money back 'No Hassle' guarantee!
  2. Mar 22, 2016 如果你的IDE出现avrdude: stk500recv: programmer is not responding的提示的时候，注意看看你的数字0和数字1是不是插着东西。如果你将数码管接到了数字0和数字1上，每次上传代码时，都要拔下来才行。.
  3. Hello, I have an Arduino uno with Atmega 328 pu and arduino ide 1.0.6programming language. I am using a Mac10.6.3. Whenever I try to upload a program, It tells me avrdude: stk500recv: programmer is not responding. I have downloaded all the drivers and normally the port that the Arduino is on starts with /dev/tty.bluetooth, but that does not show up.
  4. Avrdude: stk500recv: programmer is not responding Make sure you have selected the correct board under Tools Board. Make sure to select the correct port under Tools Port.

i have to unplug everything and start again and then it does the same - allows me to upload once etc.

Built in LED is working fine, and blinks at same rate as one that i have attached to pin13/gnd. Power LED is on constant. If I reset, both LED's flash a couple of times and then resume sequence.

Arduino board shows up in list of networks, but icon is not on desktop when i have it plugged in.

Help appreciated.

Thanks. Ben

Avrdude%3a

Avrdude Stk500_recv() Programmer Is Not Responding

On my Mac OS (El Capitan v10.11.1) using Arduino IDE 1.6.6 and Mac USB to Serial PL-2303 Driver (V2.5.0) from here (https://www.mac-usb-serial.com/dashboard/)

Arduino IDE Tools menu > Board: Arduino Mini, Processor: ATmega328, Port: /dev/cu.Repleo-PL2303-00001004, Programmer: Arduino as ISP

Avrdude: Stk500_recv(): Programmer Is Not Responding Error

Programmer cable (from http://store.cutedigi.com/ttl-uart-to-usb-cable-serial-usb-debug-cable/): Pin 1: not used, Pin 2: RxD, Pin 3: TxD, Pin 4: VCC, Pin 5: not used, Pin 6: ground

Trying to upload this ino file to enable pulse counting on the TH unit (https://github.com/openenergymonitor/emonTH/blob/master/emonTH_DHT22_DS1...)

Getting errors:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00

Avrdude: Stk500_recv(): Programmer Is Not Responding Linux

However, I can successfully upload any ino file to the emonPi and/or Tx units with success. ​I've researched the hell out of this and still cannot find the answer. Anyone know what's going on?